Honeywell CS071AE Portable Evaporative Air Cooler User Manual

Honeywell

Honeywell CS071AE Portable Evaporative Air Cooler

Honeywell CS071AE Portable Evaporative Air Cooler

About Honeywell

We hold approximately 3,000 active and pending patents worldwide for our Honeywell Home products, and we continue to create dependable technology crafted for your comfort.

Our connected technology is based on 130 years of experience and the proven expertise of the Honeywell Home brand, a brand Resideo continues to offer today.

PARTS DESCRIPTION

Honeywell CS071AE Portable Evaporative Air Cooler User Manual (1)

  1. Remote Control
  2. Control Panel
  3. Remote Control Receptor
  4. Louvers
  5. Drain Plug
  6. Water Level Indicator
  7. Casters
  8. Handle
  9. Rear Grill
  10. Water Fill Door
  11. Power Cord & Plug
  12. Rear Grill Screw

WARNING — READ AND SAVE THE AIR COOLER SAFETY & MAINTENANCE GUIDE AND USER MANUAL BEFORE USING THIS PRODUCT. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY DAMAGE AND/ OR IMPAIR ITS OPERATION AND VOID THE WARRANTY.

IN CASE THERE IS ANY INCONSISTENCY OR CONFLICT BETWEEN THE ENGLISH VERSION AND ANY OTHER LANGUAGE VERSION OF THE CONTENT OF THIS MATERIAL, THE ENGLISH VERSION SHALL PREVAIL.

USE & OPERATION

CONTROL PANEL

Honeywell CS071AE Portable Evaporative Air Cooler User Manual (2)

  • Power
  • Cool
  • Speed
  • Swing
  • Sleep
  • Timer Setting

FUNCTION BUTTONS

POWER
Press the POWER button to turn the unit on. The cooler will start automatically at medium speed. After a few seconds, the speed will switch to low. To turn the unit off, press the button again.

COOL
Please make sure water is added before setting the Cool Mode. Press the COOL button until the COOL indicator light is illuminated on the control panel.

This activates evaporative cooling. The water pump will operate and you will feel the cooler air after the Honeycomb Cooling Media is completely wet. In COOL mode, the unit may make a gargling sound when the water level is below the minimum level mark.

This is normal. Follow instructions to refill water tank with adequate water.

Note: When the COOL indicator light is switched OFF, the unit can still function in a fan-only mode (without evaporative cooling). The Sleep* function can still be switched on in a Fan-only mode.

SPEED
Press the SPEED button repeatedly to change the speed between Ultra Low – Low – Medium – High – Turbo.

The indicator light will show the selected speed:

Honeywell CS071AE Portable Evaporative Air Cooler User Manual (3)

USE & OPERATION (CONTINUED)

FUNCTION BUTTONS (CONTINUED)

TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has passed, the unit will automatically turn off (the unit remains in Standby mode until the power cord is unplugged from the electrical socket).

The TIMER function allows you to program the unit for up to 7.5 hours of use.

SWING

Press the SWING button until the SWING indicator light is illuminated on the control panel. The louvers will begin to move left to right automatically.Honeywell CS071AE Portable Evaporative Air Cooler User Manual (4)

SLEEP

When SLEEP* mode is selected, the fan speed will start running on Turbo Speed for one hour and then reduce one speed level every hour until it reaches Ultra Low speed. The fan will then remain at Ultra Low Speed until it is turned Off.

REMOTE CONTROL

Honeywell CS071AE Portable Evaporative Air Cooler User Manual (5)

  • Power: ON / OFF
  • Speed: Ultra Low / Low / Medium / High / Turbo
  • Cool: Evaporative cooling ON / OFF
  • Swing: Controls the motion of the louvers
  • Timer: Controls the Timer function for automatic off
  • Sleep: Turn ON / OFF Sleep* mode

Note:

  • The remote control requires a CR2032(1 x 3V) coin type or equivalent battery for replacement.
  • Open the battery compartment at the back of the remote control and insert a battery inside. Care must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside the battery compartment.
  • Always point the remote control signal transmitter towards the unit when operating. Make sure that the signal path is not obstructed.
  • Remove the batteries if the unit is not going to be used for an extended period.
  • Do not drop the remote control.
  • Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries. Do not mix old and new batteries.
  • Do not recharge the battery.
  • Exhausted batteries are to be removed from the product and safely disposed of as per local regulations.
  • Do not dispose of batteries in fire. Batteries may explode or leak.
    WARNING: Caution for ingestion of the small battery. Keep away from children and animals.

COOLER LOCATION
Make sure to position the air cooler correctly before you set it up and start using the COOLER LOCATION section of the separate Safety & Maintenance Guide.

FILLING WITH WATER

CAUTION:

Unplug the unit from the electrical power outlet before emptying or refilling the water tank. Open the Water Fill Door. Open the Water Fill Door located on the side of the unit. The Water Level Indicator is located at the front of the unit.

Refill the water tank when the water level is low. Do not fill water above the “Max.” water level Water Fill Door mark to avoid water droplets collecting on the louvers.

Check the water level in the tank before running the COOL function. Make sure that the water in the tank is above the minimum water level mark. Running the unit in COOL mode with inadequate water may cause pump failure.Honeywell CS071AE Portable Evaporative Air Cooler User Manual (6)

Note: The water capacity refers to the total volume of water that can be contained within the air cooler water tank and water distribution system.

The water capacity in the tank at the “Max.” indicator level may be lower than the actual water capacity of the air cooler.

Note: If ice is available, you may add ice in the top ice compartment to enhance the cooling performance.

WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and Honeycomb media.

CLEANING & DRAINING THE WATER TANK

Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used for a long time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide.

WARNING:

Before cleaning the unit, switch the unit OFF and disconnect it from the electrical socket.

  • Move the unit to a location where the water can be drained. Remove the cap from the Drain plug located at the bottom of the unit. Allow the tank to empty.
  • Refill the water tank with clean water and drain it completely.
  • Refill the water tank with clean water, up to the maximum level.
  • Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive elements or chemicals to clean this product.
  • When the product is not in use, store the unit in a dry place out of direct sunlight.

CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA

  • The appliance is supplied with a Carbon Dust Filter* & Honeycomb Cooling Media.
  • The Carbon Dust Filter* and Honeycomb Cooling Media are located inside the Rear Grill. See Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.
  • Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank and refill with fresh water, especially if the tank has not been cleaned in a long time.
  • The cleaning frequency for the Honeycomb media depends on local air and water conditions. In areas where the mineral content of water is high, mineral deposits may build up on the Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with fresh water at least once a week will help reduce mineral deposits. If mineral deposits remain on the Honeycomb Cooling Media, the media should be removed and washed under fresh water. The media should be cleaned every two months or sooner, depending on your needs.
  • For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool function 15 minutes before turning the unit off.

Honeywell CS071AE Portable Evaporative Air Cooler User Manual (7)

Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:

  1. Remove one screw from the Rear Grill of the Air Cooler.
  2. Carefully slide out the rear grill from the cooler.
  3. Slide out the Carbon Filter* and clean it with water.
  4. Pull out the Honeycomb Cooling Media.
  5. Replace or clean media with water and a damp cloth as needed.
    WARNING: DO NOT operate the Air Cooler when the Rear Grill is removed from the Air Cooler, or if there is a loose-fitting Rear Grill. Doing so can cause serious injury or dangerous electrical shock.

TECHNICAL SPECIFICATIONS

Honeywell CS071AE Portable Evaporative Air Cooler User Manual (9)

ELECTRICAL WIRING DIAGRAM

Honeywell CS071AE Portable Evaporative Air Cooler User Manual (8)

FAQS About Honeywell CS071AE Portable Evaporative Air Cooler

How does the Honeywell CS071AE Portable Evaporative Air Cooler work?

The CS071AE uses the natural process of evaporation to cool the air. It draws warm air from the surroundings, passes it through a moistened filter, and then releases the cooled air into the room. As the water evaporates, it absorbs heat from the air, resulting in a cooler and more comfortable indoor environment.

What is the cooling capacity of the Honeywell CS071AE?

The cooling capacity of the air cooler depends on factors like the room’s size, humidity level, and ambient temperature. Generally, portable evaporative air coolers like the CS071AE are suitable for cooling small to medium-sized rooms effectively.

Is the Honeywell CS071AE suitable for outdoor use?

The CS071AE is designed primarily for indoor use. Using it in an outdoor environment may not be as effective due to the open space and higher humidity levels outside, which can limit the cooling effect of the evaporative air cooler.

How do I maintain and clean the Honeywell CS071AE?

Regular maintenance and cleaning are essential to ensure the optimal performance of the air cooler. Refer to the product manual for detailed instructions on how to clean and maintain the unit properly.

Does the Honeywell CS071AE require a water source?

Yes, the Honeywell CS071AE requires a water source to function. You’ll need to fill the water tank or water reservoir with water for the evaporative cooling process to work effectively.

Can the Honeywell CS071AE be used in humid climates?

Evaporative air coolers are generally more effective in dry climates because they rely on the evaporation of water to cool the air. In humid climates, the cooling effect may be limited as the air’s capacity to hold moisture is already high.

Does the Honeywell CS071AE require an exhaust hose like an air conditioner?

No, portable evaporative air coolers like the CS071AE do not require an exhaust hose as they do not produce hot air like traditional air conditioners. They use the evaporation process to cool the air, and the cooled air is released into the room.

For More Manuals by Honeywell, Visit the Latest Manual

Honeywell CS071AE Portable Evaporative Air Cooler User Manual [pdf]
Tags: ,

Leave a Reply