HoneyWell TC10PE Portable Evaporative Air Cooler User Manual

Honeywell

HoneyWell TC10PE Portable Evaporative Air Cooler

HoneyWell TC10PE Portable Evaporative Air Cooler

About Honeywell

We hold approximately 3,000 active and pending patents worldwide for our Honeywell Home products, and we continue to create dependable technology crafted for your comfort.

Our connected technology is based on 130 years of experience and the proven expertise of the Honeywell Home brand, a brand Resideo continues to offer today.

PARTS DESCRIPTION

HoneyWell TC10PE Portable Evaporative Air Cooler fig-1

  1. Control Panel
  2. Louvers
  3. Water Level Indicator
  4. Casters
  5. Handle
  6. Remote Control
  7. Rear Grill & Mesh Filter
  8. Honeycomb Cooling Media
  9. Water Fill Door
  10. Power Cord & Plug
  11. Drain Plug

WARNING — READ AND SAVE THE AIR COOLER SAFETY & MAINTENANCE GUIDE AND USER MANUAL BEFORE USING THIS PRODUCT. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY DAMAGE AND/ OR IMPAIR ITS OPERATION AND VOID THE WARRANTY.

IN CASE THERE IS ANY INCONSISTENCY OR CONFLICT BETWEEN THE ENGLISH VERSION AND ANY OTHER LANGUAGE VERSION OF THE CONTENT OF THIS MATERIAL, THE ENGLISH VERSION SHALL PREVAIL.

USE & OPERATION

CONTROL PANEL

HoneyWell TC10PE Portable Evaporative Air Cooler User Manual (1)

FUNCTION BUTTONS

  • POWER
    Press the button to turn the unit on. The cooler will start automatically at medium speed. After a few seconds, the speed will switch to low. To turn the unit off, press the button again.
  • COOL
    You must add water before operating the unit in Cool mode. Press the button until is illuminated on the display screen. The water pump will operate and you will feel the cooler air after the Honeycomb Cooling Media is completely wet.
  • SPEED
    Press the SPEED button repeatedly to change the speed between | – || – |||.
  • SWING
    Press the SWING button until is illuminated on the display. The louvers will begin to move left to right automatically. You can manually adjust the louvers to change vertical airflow. HoneyWell TC10PE Portable Evaporative Air Cooler User Manual (2)

REMOTE CONTROL

HoneyWell TC10PE Portable Evaporative Air Cooler User Manual (4)

NOTE:

  • The remote control requires a CR2025 (1 x 3V) coin type or equivalent battery for replacement. Open the battery compartment at the back of the remote control and insert the battery inside. Care must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside the battery compartment.
  • Always point the remote control signal transmitter towards the unit when operating. Make sure that the signal path is not obstructed.
  • Remove the batteries if the unit is not going to be used for an extended period of time.
  • Do not drop the remote control.
  • Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries. Do not mix old and new batteries.
  • Do not recharge the battery.
  • Exhausted batteries are to be removed from the product and safely disposed of as per local regulations.
  • Do not dispose of batteries in a fire. Batteries may explode or leak.
  • This product contains a lithium button/coin cell battery. If a new or used lithium button/ coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
  • The batteries shall be disposed of properly, including keeping them away from children.
  • Even used batteries may cause injury.

WARNING: Chemical Burn Hazard. Keep batteries away from children.

COOLER LOCATION

Make sure to position the air cooler correctly before you set up and start using the product. Please refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.

FILLING WITH WATER

HoneyWell TC10PE Portable Evaporative Air Cooler User Manual (5)

CAUTION: Unplug the unit from the electrical socket before emptying or refilling the water tank.

Open the Water Fill Door located on the back of the unit.

Manual Tank Refilling:

The Water Level Indicator is located at the front of the unit. Refill the water tank when the water level is low. Do not fill water above the “Max.” water level mark to avoid water droplets collecting on the louvers.

Check the water level in the tank before running the COOL function. Make sure that the water in the tank is above the minimum water level mark. Running the unit in COOL mode with inadequate water may cause pump failure.

Note:

The water capacity refers to the total volume of water that can be contained within the air cooler water tank and water distribution system. The water capacity in the tank at the “Max.” indicator level may be lower than the actual water capacity of the air cooler.

WARNING:

Do not fill the water tank with dirty water or salt water. This can damage the unit and Honeycomb media.

LOW WATER ALARM

The unit is equipped with a low water sensor. In Cooling Mode, when water in the tank is below the minimum level, you will hear a beeping sound, and the GREEN LED will flash continuously.

The unit will automatically pause evaporative cooling. Refill the water tank to deactivate the alarm in cooling mode. First, switch OFF the unit and unplug from the power outlet.

Fill the water tank with water above the minimum water level mark. Plug in and switch ON again. To deactivate the alarm and continue using the unit as a fan (without evaporative cooling), switch the unit OFF and then ON again.

The Low Water Alarm will not activate in Fan-only mode. The Low Water Alarm will sound again if the COOL function is activated while the water tank is still empty.

CLEANING & DRAINING THE WATER TANK

Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used for a long period, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide.

WARNING:

Before cleaning the unit, power OFF the unit and disconnect it from the electrical socket.

  • Move the unit to a location where the water can be drained. Remove the cap from the drain plug located at the bottom of the unit. Allow the tank to empty.
  • Refill the water tank with clean water, up to the maximum level and drain it completely.
  • Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive elements or chemicals to clean this product.
  • When the product is not in use, store the unit in a dry place out of direct sunlight.

CLEANING THE HONEYCOMB COOLING MEDIA

WARNING:

Before cleaning the unit, switch the unit OFF and disconnect the power adapter from the unit and the electrical socket.

  • The appliance is supplied with a Honeycomb Cooling Media.
  • The Honeycomb Cooling Media are located inside the Side Grill. See Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.HoneyWell TC10PE Portable Evaporative Air Cooler User Manual (6)
  • Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank and refill it with fresh water, especially if the tank has not been cleaned in a long time.
  • The cleaning frequency for the Honeycomb media depends on local air and water conditions. In areas where the mineral content of water is high, mineral deposits may build up on the Honeycomb Cooling
  • Media and restrict airflow. Draining the water tank and refilling it with fresh water at least once a week will help reduce mineral deposits. If mineral deposits remain on the Honeycomb Cooling Media, the media should be removed and washed under fresh water. The media should be cleaned every two months or sooner, depending on your needs.
  • For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool function 15 minutes before turning the unit off.

Removing the Honeycomb Cooling Media:

  1. Remove all the screws from the side grill of the Air Cooler, and carefully pull out the side grill from the cooler.
  2. Rinse the side grill with clean water and let it dry before re-installing to the unit.
  3. Carefully pull out the Honeycomb Media from the unit.
  4. Replace or clean media with water and a damp cloth as needed.

WARNING:

DO NOT operate the Air Cooler when the side Grill is removed from the Air Cooler, or if there is a loose-fitting side Grill. Doing so can cause serious injury or dangerous electrical shock.

FAQS About Honeywell TC10PE Portable Evaporative Air Cooler

How does a portable evaporative air cooler work?

Evaporative air coolers work by drawing warm air through water-saturated cooling pads. The water evaporates, which cools down the air, and then the cooler fan blows this cooled air into the room.

What is the cooling capacity of the HoneyWell TC10PE Portable Evaporative Air Cooler?

You’ll need to refer to the product specifications or the manufacturer’s website for the specific cooling capacity of the TC10PE model.

How large of an area can the Honeywell TC10PE cool?

The cooling area will depend on the specific model and its cooling capacity. Generally, portable evaporative air coolers are effective in smaller spaces like bedrooms, offices, or small living areas.

Is the Honeywell TC10PE suitable for outdoor use?

Some portable evaporative air coolers can be used in outdoor areas like patios, decks, or garages. However, it’s essential to check the product’s user manual or manufacturer’s guidelines to ensure its suitability for outdoor use.

How much water does the Honeywell TC10PE evaporative air cooler hold?

The water tank capacity of portable evaporative air coolers varies from model to model. The TC10PE’s water tank capacity should be mentioned in the product specifications.

Does the Honeywell TC10PE require any installation?

Most portable evaporative air coolers are designed for easy setup and do not require complicated installation. They typically come with a user manual that guides you through the setup process.

Does the Honeywell TC10PE require a constant water supply?

Portable evaporative air coolers generally come with a water tank that needs to be filled manually. Some models may have the option to connect to a water supply for continuous operation.

Can I use the Honeywell TC10PE in a humid climate?

Evaporative air coolers work best in dry climates where the cooling effect of evaporation is most efficient. In humid climates, their effectiveness may be limited.

How much power does the Honeywell TC10PE consume?

The power consumption of the TC10PE will depend on its specific model and cooling capacity. Refer to the product specifications for detailed power consumption information.

For More Manuals by Honeywell, Visit the Latest Manual

HoneyWell TC10PE Portable Evaporative Air Cooler User Manual [pdf]

Leave a Reply